7219.32.00 - Of a thickness of 3 mm or more but less than 4.75 mm

This HTS category, 7219.32.00, specifically covers flat-rolled products of stainless steel that are of a width of 600 mm or more and have been cold-rolled. The defining characteristic for this sub-classification is the thickness of the material, which must be 3 mm or more but less than 4.75 mm. These are finished goods that are ready for further fabrication or direct use, maintaining the precise dimensional tolerances achieved through cold-rolling.

Distinguishing this category from its siblings is crucial for accurate classification. Unlike 7219.31.00, which encompasses thicker materials (4.75 mm or more), or categories covering thicknesses less than 3 mm (7219.33.00, 7219.34.00, and 7219.35.00), this classification focuses on a very specific intermediate thickness range. The cold-rolled finish implies a smoother surface and tighter dimensional control compared to hot-rolled products.

The subcategories under 7219.32.00 further refine the classification based on whether the product is presented in coils or not in coils. This distinction is important for logistical and commercial purposes, as well as for potential differences in further processing or application. Goods presented "in coils" have typically undergone a continuous rolling process without interruption and are wound for storage and transport, while those "not in coils" have been cut to specific lengths.